642-980 DCUFT Online Test-Troubleshooting Cisco Data Center Unified Fabric(DCUFT)

Why not selecting 642-980 DCUFT online test? Now, 642-980 DCUFT online test would be the best way to practice your Cisco 642-980 DCUFT test. Take 642-980 DCUFT online test for a through learning skill on 642-980 DCUFT exam. From 642-980 DCUFT online test, you can practice Cisco 642-980 DCUFT pdf questions and answers totally. That will make you get high score on you 642-980 DCUFT test. That’s very clearly, 642-980 DCUFT online test will ensure you pass 642-980 DCUFT test, further, get your Cisco certification smoothly.

Here, 642-980 DCUFT online test offer 10 questions for practicing. 642-980 DCUFT online test contain single choice and multiple choice, we have set the 10 points for each question. If answer correctly when testing, you will earn corresponding scores. More practice, higher score.

Begin to test now!

When you look at the HSRP state for devices on a VLAN that is extended by OTV, you see the following states: Active, Standby, and Listen. However, you intended each data center device to show the state as Active and Standby.
What is the problem?


What are the two most common causes of the “SFP validation failed” error on an interface when you attempt to connect a Cisco Nexus 2148T Fabric Extender to a Cisco Nexus 5548UP Switch? (Choose two.)


Which three commands will help an administrator identify any issues with an In-Service Software Upgrade? (Choose three.)


When you ping your new Cisco Nexus 7010 Switch, you see this output:
What could be the problem?


What are three situations that may cause an ISSU failure? (Choose three.)


Storage VDC creation has failed. Which two steps should be taken before creating the storage VDC? (Choose two.)


A Cisco Nexus 7010 Switch that is at the core of a customer network has high CPU utilization.
What can the customer do to prevent a network outage and identify why CPU utilization is high?


Which two occurrences happen during an ISSU? (Choose two.)


Which two statements are true about the OTV otv site-identifier id command? (Choose two.)


Which two fields should be examined when you use the show otv overlay command to verify that the overlay interface is enabled and the parameters match on both sides? (Choose two.)


Question 1 of 10


Leave a Reply

Your email address will not be published. Required fields are marked *