642-035 DCUCT Online Test-Troubleshooting Cisco Data Center Unified Computing(DCUCT)

Why not selecting 642-035 DCUCT online test? Now, 642-035 DCUCT online test would be the best way to practice your Cisco 642-035 DCUCT test. Take 642-035 DCUCT online test for a through learning skill on 642-035 DCUCT exam. From 642-035 DCUCT online test, you can practice Cisco 642-035 DCUCT pdf questions and answers totally. That will make you get high score on you 642-035 DCUCT test. That’s very clearly, 642-035 DCUCT online test will ensure you pass 642-035 DCUCT test, further, get your Cisco certification smoothly.

Here, 642-035 DCUCT online test offer 10 questions for practicing. 642-035 DCUCT online test contain single choice and multiple choice, we have set the 10 points for each question. If answer correctly when testing, you will earn corresponding scores. More practice, higher score.

Begin to test now!

The Cisco UCS Manager displays FSM information for which four of these? (Choose four.)

 
 
 
 
 
 
 

After migrating a server that is configured with dynamic vNICs, Cisco UCS Manager assigns new dynamic vNICs to the server.
If you had been monitoring traffic on an original dynamic vNIC, what must you do when the server comes back up?”

 
 
 
 
 

Where do you configure users so that they cannot access resources that belong to other organizations?

 
 
 
 

Which logs are used to troubleshoot hardware failure?

 
 
 
 
 

Which command on the Fabric Interconnect displays packet statistics for a given QoS group and MTU size?

 
 
 
 
 

On a Cisco UCS B-Series data center environment; how many default roles are there when utilizing RBAC for security restriction?

 
 
 
 
 

A customer calls in a trouble ticket and explains that after a power failure, the UPS was discovered to be defective and the Cisco UCS C210 M2 server running Windows 2008 R2 went down without proper shutdown. After restarting the server, you discover the RAID 5 array rebuilding parity.
Which write-cache settings on the LSI MegaRAID 9260-4i controller explain this symptom?

 
 
 
 
 

A Cisco UCS chassis has two ports on I/O Module 1 connected to Fabric Interconnect A, and two ports on I/O Module 2 connected to Fabric Interconnect B. The I/O modules are connected to ports 1 and 2 on their respective fabric interconnects, and end host mode is configured.
After a link failure occurs on port 1 of I/O Module 1, what happens to the traffic that was pinned to that link?

 
 
 
 

On a Cisco Nexus 5000 Series Switch, which two options are valid traffic sources that can be monitored, when configuring a SPAN session for a port channel?

 
 
 
 

You attempt to boot a supported Linux operating system live image from the eUSB in a Cisco UCS blade-server environment, but the boot fails.
Which option is the most likely cause of the failure?

 
 
 
 

Question 1 of 10


buy1

Leave a Reply

Your email address will not be published. Required fields are marked *


*