640-864 DESGN Online Test-Designing for Cisco Internetwork Solutions (DESGN)

Why not selecting 640-864 DESGN online test? Now, 640-864 DESGN online test would be the best way to practice your Cisco 640-864 DESGN test. Take 640-864 DESGN online test for a through learning skill on 640-864 DESGN exam. From 640-864 DESGN online test, you can practice Cisco 640-864 DESGN pdf questions and answers totally. That will make you get high score on you 640-864 DESGN test. That’s very clearly, 640-864 DESGN online test will ensure you pass 640-864 DESGN test, further, get your Cisco certification smoothly.

Here, 640-864 DESGN online test offer 20 questions for practicing. 640-864 DESGN online test contain single choice and multiple choice, we have set the 5 points for each question. If answer correctly when testing, you will earn corresponding scores. More practice, higher score.

Begin to test now!

Which two enterprise campus layers are combined in a medium-sized LAN? (Choose two.)


What is a characteristic of campus core designs?


Which servers that reside in the data center require direct links to all other enterprise modules?


Which Gigabit Ethernet media type provides the longest reach without a repeater?


Which three options represents the components of the Teleworker Solution? (Choose three.)


What is the maximum number of groups that is supported by GLBP?


Which three service categories are supported by an ISR? (Choose three.)


Which three protocols support VLSM? (Choose three.)


ACME corporation is implementing dynamic routing on the LAN at its corporate headquarters. The interior gateway protocol that they select must support these requirements: multivendor environment, efficient subnetting, high scalability, and fast convergence. Which interior gateway protocol should they implement?


Which routing protocol classification should you use when full topology information is needed?


When you are designing a large IPv6 multivendor network, which IGP does Cisco recommend that you use?


Which is the equation used to derive a 64 Kbps bit rate?


When designing the infrastructure protection portion for the enterprise edge, which solution would be the most appropriate solution to consider?


Which two design approaches provide management of enterprise network devices? (Choose two.)


Refer to the list of requirements.
– Must be a single, large location with many remote sites
– Must have multisite WAN connectivity
– Requires SRST for call processing redundancy
Which IP telephony design model should you implement to fulfill these requirements?


What are the three modes of unicast reverse path forwarding? (Choose three.)


Which network access control technology is recommended to use with Layer 2 access layer switches?


Which technology enables WLCs to peer with each other to enable roaming support?


Which IP telephony component supports VoIP, PoE, and QoS?


Which statement describes a unique advantage of EIGRP?


Question 1 of 20


Leave a Reply

Your email address will not be published. Required fields are marked *