300-115 SWITCH Online Test-Implementing Cisco IP Switched Networks(SWITCH)

Why not selecting 300-115 SWITCH online test? Now, 300-115 SWITCH online test would be the best way to practice your Cisco 300-115 SWITCH test. Take 300-115 SWITCH online test for a through learning skill on 300-115 SWITCH exam. From 300-115 SWITCH online test, you can practice Cisco 300-115 SWITCH pdf questions and answers totally. That will make you get high score on you 300-115 SWITCH test. That’s very clearly, 300-115 SWITCH online test will ensure you pass 300-115 SWITCH test, further, get your Cisco certification smoothly.

Here, 300-115 SWITCH online test offer 10 questions for practicing. 300-115 SWITCH online test contain single choice and multiple choice, we have set the 10 points for each question. If answer correctly when testing, you will earn corresponding scores. More practice, higher score.

Begin to test now!

What is the maximum number of switches that can be stacked using Cisco StackWise?

 
 
 
 
 
 

A network engineer wants to add a new switch to an existing switch stack.
Which configuration must be added to the new switch before it can be added to the switch stack?

 
 
 
 
 

What percentage of bandwidth is reduced when a stack cable is broken?

 
 
 
 
 

After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the down/ down state. Switch A is configured with channel-group 1 mode active, while Switch B is configured with channel-group 1 mode desirable.
Why is the EtherChannel bundle not working?

 
 
 
 

An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the EtherChannel links is being utilized to reach the web server.
What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate web server?

 
 
 
 
 

Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs. This command is configured globally: monitor session 2 filter vlan 1 – 8, 39, 52
What is the result of the implemented command?

 
 
 
 
 

A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor relationships.
What would cause the output to show only the single neighbor?

 
 
 
 

After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco Discovery Protocol are not visible.
Which vendor-neutral protocol could be used to resolve this issue?

 
 
 
 

Several new switches have been added to the existing network as VTP clients. All of the new switches have been configured with the same VTP domain, password, and version. However, VLANs are not passing from the VTP server (existing network) to the VTP clients.
What must be done to fix this?

 
 
 
 

After implementing VTP, the extended VLANs are not being propagated to other VTP switches.
What should be configured for extended VLANs?

 
 
 
 

Question 1 of 10


buy1