200-101 ICND2 Online Test-Interconnecting Cisco Networking Devices Part 2 (ICND2)

Why not selecting 200-101 ICND2 online test? Now, 200-101 ICND2 online test would be the best way to practice your Cisco 200-101 ICND2 test. Take 200-101 ICND2 online test for a through learning skill on 200-101 ICND2 exam. From 200-101 ICND2 online test, you can practice Cisco 200-101 ICND2 pdf questions and answers totally. That will make you get high score on you 200-101 ICND2 test. That’s very clearly, 200-101 ICND2 online test will ensure you pass 200-101 ICND2 test, further, get your Cisco certification smoothly.

Here, 200-101 ICND2 online test offer 20 questions for practicing. 200-101 ICND2 online test contain single choice and multiple choice, we have set the 5 points for each question. If answer correctly when testing, you will earn corresponding scores. More practice, higher score.

Begin to test now!

What are two drawbacks of implementing a link-state routing protocol? (Choose two.)


Which two are advantages of static routing when compared to dynamic routing? (Choose two.)


A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default characteristics. Each process learns a route to the same remote network.
If there are no static routes to the destination and none of the routes were redistributed, which route will be placed in the IP routing table?


What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is in active status?


Which command is used to display the collection of OSPF link states?


What is the default administrative distance of OSPF?


What information does a router running a link-state protocol use to build and maintain its topological database? (Choose two.)


Which commands are required to properly configure a router to run OSPF and to add network to OSPF area 0? (Choose two.)


Which type of EIGRP route entry describes a feasible successor?


What OSPF command, when configured, will include all interfaces into area 0?


Which statement describes the process ID that is used to run OSPF on a router?


Which two statements about the OSPF Router ID are true? (Choose two.)


What are two benefits of using a single OSPF area network design? (Choose two.)


What can cause two OSPF neighbors to be stuck in the EXSTART state?


What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.)


What are the two default metrics used by EIGRP for route selection? (Choose two.)


Which statement describes an EIGRP feasible successor route?


A network administrator is troubleshooting an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?


A router receives information about network from multiple sources. What will the router consider the most reliable information about the path to that network?


When a router undergoes the exchange protocol within OSPF, in what order does it pass through each state?


Question 1 of 20